Keithley 4200A-SCS Reference Manual page 1226

Hide thumbs Also See for 4200A-SCS:

Table of Contents

Model 4200A-SCS Parameter Analyzer Reference Manual

Appendix F: Set up a probe station

Figure 627: Chuck movement

At the conclusion of a test, the site coordinates are recorded in the sheet settings. These coordinates

are only valid if a project uses the remote prober control (real prober). The coordinate system is

based on the xstart_position and ystart_position parameters of the prober-init action.

The site coordinates change only after a site movement is performed; the coordinates change when

the bottom of the project loop is reached. At the top of each iteration, the site coordinates remain the

same until the site movement is done. Refer to the following figure for an example of a table that

contains site coordinates (see column B, row 9).

4200A-901-01 Rev. C / February 2017