Example Test Execution Sequence: Probesites Project - Keithley 4200A-SCS Reference Manual

Hide thumbs Also See for 4200A-SCS:

Table of Contents

Model 4200A-SCS Parameter Analyzer Reference Manual

Appendix F: Set up a probe station

Example test execution sequence: probesites project

Configure the probesites project:

1. In Clarius, select Configure.

2. In the project tree, select probesites.

3. Set the Project Execution Loop Settings as needed for your project. The example below shows

the settings for a project with five sites.

Figure 623: Project Execution Loop Settings

4. Select Run.

5. Select Analyze to review the data.

4200A-901-01 Rev. C / February 2017