Using Kcon To Add A Keysight Pulse Generator To The System; Hp8110Ulib User Library - Keithley 4200A-SCS Reference Manual

Appendix E: Using a Keysight 8110A/8111A Pulse Generator

Using KCon to add a Keysight pulse generator to the system

In order for the 4200A-SCS to control an external instrument, that instrument must be added to the
system configuration. The pulse generator is added to the test system using the Keithley
Configuration Utility (KCon).
Refer to Using KCon to add equipment to the 4200A-SCS
For additional detail on KCon, refer to

HP8110ulib user library

Use the user modules in the HP8110ulib user library to control a Keysight Model 8110A Pulse
Generator. These user modules are summarized in the following table. The table also lists the user
test modules (UTM) created by Keithley Instruments that use the user modules.
HP8110ulib user modules
User Module
PguInit8110 (on
page E-5)
PguSetup8110
page E-6)
PguTrigger8110
page E-8)
E-4
Keithley Configuration Utility
UTM Name Description
pgu1-init Initializes the pulse generator to the default setup.
(on pgu1-setup Sets the output pulse parameters.
(on pgu-trigger Specifies pulse count and trigger start of output.
Model 4200A-SCS Parameter Analyzer Reference Manual
(on page 7-7) for instruction.
(on page 7-1).
4200A-901-01 Rev. C / February 2017