Keithley 4200A-SCS Reference Manual page 396

Model 4200A-SCS Parameter Analyzer Reference Manual
SegARBConfig
The SegARBConfig is the most complex control type available for the UTM UI. The Segment Arb
mode has many parameters, with most of them in arrays. This control type provides the interface to
user modules making use of two specific LPT commands:
seg_arb_waveform
Key Parameters:
•
The UTM UI Parameter Configuration dialog box, shown in the figure below. This dialog box is
the primary dialog box that you use to configure the SegARBConfig control.
•
The Segment Arb Defaults Configuration dialog box, shown in the figure "Segment Arb Defaults
Configuration" shown in
4200A-901-01 Rev. C / February 2017
(on page 13-128). There are two dialog boxes that configure the Segment Arb UI
Starting with default waveforms
Figure 287: SegARBConfig UTM UI Parameter Configuration dialog box
seg_arb_sequence (on page 13-125) and
(on page 6-134).
Section 6: Clarius
®
6-127