Model 4200A-SCS Parameter Analyzer Reference Manual
Using KCon to add 590 C-V Analyzer to system
To use the 4200A-SCS to control an external instrument, that instrument must be added to the
system configuration. The 590 C-V Analyzer is added to the test system using the Keithley
Configuration Utility (KCon).
Refer to
For additional detail on KCon, refer to
Model 590 test examples
The test examples for the Model 590 C-V Analyzer are controlled by user test modules (UTMs) in the
ivcvswitch project. The following figure shows the tree for the project.
A switch matrix is not used for these examples.
4200A-901-01 Rev. C / February 2017
Use KCon to add equipment to the 4200A-SCS
Figure 551: Project tree when ivcvswitch project is selected
Appendix B: Using a Model 590 C-V Analyzer
(on page 7-7) for instruction.
Keithley Configuration Utility (KCon)
(on page 7-1).
B-5