Custom Arb File Operation: Select And Configure Waveforms - Keithley 4200A-SCS Reference Manual

Hide thumbs Also See for 4200A-SCS:

Table of Contents

Section 10: KPulse (for Keithley Pulse Cards)

Custom Arb file operation: Select and configure waveforms

To select and configure waveforms:

1. Select the Arb Generator tab.

2. Select New Waveform to open the Waveform Generator dialog box, shown in the following

3. Select the Waveform Type to be created.

4. Configure the Settings for the selected waveform type.

5. Select Preview to update the preview of the waveform.

6. In the Waveform Name field, type in a name for the waveform. You cannot use a name that is

already used in the Scratch Pad.

7. Select OK to create the waveform. The new waveform is added to the Scratch Pad.

8. Repeat these steps to create another waveform in the Scratch Pad.

Figure 475: Custom Arb file operation: Select and configure waveforms

Model 4200A-SCS Parameter Analyzer Reference Manual

4200A-901-01 Rev. C / February 2017