Using A Cascade Summit-12000 Prober; Cascade Summit 12000 Prober Software; Software Version; Probe Station Configuration - Keithley 4200A-SCS Reference Manual

Hide thumbs Also See for 4200A-SCS:

Table of Contents

In this appendix:

Use the following program, which is on the Summit 12000, to configure and operate the Summit

12000 prober with the Keithley Instruments 4200A-SCS:

Nucleus UI prober control software: Provides access to configuration and help programs.

The following software version was used to verify the configuration of the Summit-12000 prober with

the 4200A-SCS:

Nucleus UI ver. 2.0

Make sure that you are familiar with the Cascade Summit-12000 Prober and its supporting

documentation before attempting setup, configuration, or operation.

The general steps required to set up and configure the Summit-120000 prober for use with the

Set up wafer geometry

Create a site definition and define a probe list

Load, align, and contact the wafer

Set up communications

The Cascade Summit-12000 prober is configured for GPIB communications only. Make sure that the

prober configuration file is set up properly for the GPIB communications interface. See

prober configuration file

Using a Cascade Summit-12000 Prober

Cascade Summit 12000 prober software ................................. J-1

Probe station configuration ....................................................... J-1

Probesites Clarius Project example ........................................ J-19

Probesubsites Clarius Project example .................................. J-21

Commands and error symbols ............................................... J-27

(on page J-1)

(on page J-8)

(on page J-7) for information.

(on page J-13)

(on page J-15)

Modifying the