Section 9: Keithley External Control Interface (KXCI)
Data output and file commands
The data output and file commands command strings are valid in any system mode page. They are:
•
DO command: Obtain output data
•
SR command: Set fixed source range
•
SV command: Save file
•
GT command: Get file
•
MP command: Map channel
User mode commands
The user mode commands are listed in the following. Full descriptions are provided in
commands
(on page 9-39).
•
DV and DI commands: SMU setup
•
DS Command: VS1...VS9 setup
•
TV and TI commands: Triggering
Commands common to system and user modes
Some commands are common to the system and user modes, as listed below. Descriptions of these
commands are provided in
•
IT command: Set integration time
•
ID command: Retrieve instrument ID
•
DR: Control service request for Data Ready
•
BC command: Clear data buffer
•
RS command: Set global measurement resolution
•
RI command: Instruct a SMU to go a specified range
•
RG command: Set the lowest current-measurement range
•
AC command: Perform autocalibration
•
EC command: Exit on compliance
•
EM command: Switch between 4145 and 4200 modes
4200A command set only
The 4200A command set only command is:
•
*OPT?: Get KXCI configuration of the 4200A-SCS
9-12
Model 4200A-SCS Parameter Analyzer Reference Manual
(on page 9-36)
(on page 9-39)
(on page 9-37)
(on page 9-37)
(on page 9-38)
(on page 9-40)
(on page 9-41)
(on page 9-42)
Commands common to system and user modes
(on page 9-44)
(on page 9-45)
(on page 9-45)
(on page 9-46)
(on page 9-47)
(on page 9-48)
(on page 9-43).
(on page 9-46)
(on page 9-46)
(on page 9-47)
(on page 9-48)
(on page 9-49)
4200A-901-01 Rev. C / February 2017
User mode