Agilent Technologies E5071C Manual page 993

E5071C
These lines store the settings of continuous initiation mode for each
channel (on for channels 1 and 2; off for channels 3 through 9) into the
array variable Cont_mode$(*).
Lines 160 to 180
These lines turn on or off continuous initiation mode for each channel
depending on the value of Cont_mode$(*).
Line 190
Sets the trigger source to "Bus Trigger".
Lines 210 to 220
These lines configure the instrument so that operation status event
register's bit 4 is set to 1 only when the operation status condition
register's bit 4 is changed from 1 to 0 (negative transition).
Lines 230 to 240
These lines enable the operation status event register's bit 4 and status
byte register's bit 7.
Lines 250 to 270
These lines clear the status byte register and operation status event
register.
Lines 290 to 300
These lines set the branch target for an SRQ interrupt to enable SRQ
interruptions.
Lines 310 to 320
These lines trigger the instrument and wait until the measurement cycle
finishes.
Line 350
Displays a measurement completion message.
1220