Interface Range - Dell PowerConnect W-7200 Series Reference Manual

interface range

interface range {fastethernet|gigabitethernet} <slot>/<port>-<port>
duplex {auto|full|half}
ip access-group <acl> {in|out|session {vlan <vlanId>}}
no ...
poe [cisco]
shutdown
spanning-tree [cost <value>] [port-priority <value>] [portfast]
speed {10|100|auto}
switchport {access vlan <vlan>|mode {access|trunk}|
trunk {allowed vlan {<vlans>|add <vlans>|all|except <vlans>|remove <vlans>}|
native vlan <vlan>}}
trusted {vlan <word>}
Description
This command configures a range of FastEthernet or GigabitEthernet interfaces on the controller.
Syntax
Parameter
range
duplex
ip access-group
in
out
session
no
poe
cisco
shutdown
spanning-tree
cost
port-priority
324 | interface range
Description
Range of Ethernet ports in the format <slot>/<port>-<port>.
Transmission mode on the interface: full- or half-duplex or
auto to automatically adjust transmission.
Applies the specified access control list (ACL) to the
interface. Use the ip access-list command to configure an
ACL.
Applies ACL to interface's inbound traffic.
Applies ACL to interface's outbound traffic.
Applies session ACL to interface and optionally to a selected
VLAN associated with this port.
Negates any configured parameter.
Enables Power-over-Ethernet (PoE) on the interface.
Enables Cisco-style PoE on the interface.
Causes a hard shutdown of the interface.
Enables spanning tree.
Administrative cost associated with the spanning tree.
Spanning tree priority of the interface. A lower setting brings
the port closer to root port position (favorable for forwarding
traffic) than does a higher setting. This is useful if ports may
contend for root position if they are connected to an identical
bridge.
Range
—
auto/full/hal-
f
—
—
—
—
—
—
—
—
—
1-65535
0-255
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Default
—
auto
—
—
—
—
—
—
—
—
—
—