Interface Tunnel - Dell PowerConnect W-7200 Series Reference Manual

interface tunnel

interface tunnel <number>
description <string>
inter-tunnel-flooding
ip address <ipaddr> <netmask>
mtu <mtu>
no ...
shutdown
trusted
tunnel checksum|destination <ipaddr>|keepalive [<interval> <retries>]|key <key>|mode gre
{<protocol>|ip}|source {<ipaddr>|loopback|vlan <vlan>}|vlan <vlans>
Description
This command configures a tunnel interface.
Syntax
Parameter
tunnel
description
inter-tunnel-
flooding
ip address
mtu
no
shutdown
trusted
tunnel
checksum
destination
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Identification number for the tunnel.
String that describes this interface.
Enables inter-tunnel flooding.
IP address of the tunnel. This represents the entrance to
the tunnel.
MTU size for the interface.
Negates any configured parameter.
Causes a hard shutdown of the interface.
Set this interface and range of VLANs to be trusted. VLANs
not included in the trusted range of VLANs will be, by
default, untrusted.
Trusted ports and VLANs are typically connected to
internal controlled networks, while untrusted ports
connect to third-party APs, public areas, or other
networks to which access controls should be applied.
When Dell APs are attached directly to the controller, set
the port to be trusted.
Configures tunneling.
Enables end-to-end checksum of packets that pass
through the tunnel.
Destination IP address for the tunnel endpoint.
Range Default
1-2147483647 —
— Tunnel
Interface
— enabled
— —
1024 - 9216 —
— —
— —
— disabled
— mode gre
ip
— disabled
— —
interface tunnel | 327