Configuring The Isdn Signaling (Switch) Type - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

For example, if the ISDN module is located in slot 1 and you are configuring
the interface for port 2, enter.
ProCurve(config)# interface bri 1/2
The prompt should indicate that you have entered the appropriate interface
configuration mode context:
ProCurve(config-bri 1/2)#

Configuring the ISDN Signaling (Switch) Type

The ProCurve Secure Router ISDN module supports the AT&T 5ESS, Northern
DMS-100, Euro NET3, and National ISDN-1 standards. You must configure the
BRI interface to use the ISDN signaling that your public carrier uses. The
signaling type does not necessarily have to be that of the ISDN switch's
manufacturer. For example, a Lucent switch can implement National ISDN-1
signaling. Your public carrier should inform you which signaling method
it uses.
To set the signaling type, enter the following command from the BRI interface
configuration mode context:
Syntax: isdn switch-type [basic-5ess | basic-dms | basic-net3 | basic-ni]
ProCurve(config-bri 1/2)# isdn switch-type basic-5ess
Table 8-8 lists the command syntax for specifying each signaling type.
Table 8-8. ISDN Signaling Types
Signaling Type
National ISDN-1
Euro ISDN
Northern Telecom DMS-100
Lucent/ATT 5ESS
The default settings are:
ISDN BRI U modules, isdn switch-type basic-5ess
ISDN BRI S/T modules, isdn switch-type basic-net3
Configuring Demand Routing for Primary ISDN Modules
Using Demand Routing for ISDN Connections
Command Syntax
isdn switch-type basic-ni
isdn switch-type basic-net3
isdn switch-type basic-dms
isdn switch-type basic-5ess
8-41