Rep 10.5 Exit Gate Solenoid; Rep 10.6 Eliminator Assembly - Xerox DocuPrint N2025 Service Manual

REP 10.5 Exit Gate Solenoid

Parts List on PL 10.1
Removal
Switch off the power and disconnect the Power Cord.
1. Open the printer Rear Cover.
2. Press the locking tab and disconnect P/J519 from the Rear Cover (Figure 1).
3. Press the locking tab on the Solenoid Assembly and remove (Figure 1).
Figure 1 Exit Gate Solenoid
Replacement
1. Reinstall the components in the reverse order.
Initial Issue
DocuPrint N2025/N2825
WARNING

REP 10.6 Eliminator Assembly

Parts List on PL 10.2
Removal
Switch off the power and disconnect the Power Cord.
1. Open the OCT Rear Cover.
2. Remove the OCT Top Cover (REP 10.2).
3. Remove the Stack Full Sensor (REP 10.7).
4. Remove the two screws that secure the Eliminator Assembly to the OCT (Figure 1).
5. Remove the Eliminator Assembly (Figure 1).
Figure 1 Eliminator Assembly
Replacement
1. If replacing the Eliminator Assembly, remove the Stack Full Sensor Actuator (REP 10.8)
and place on the new assembly.
2. Reinstall the components in the reverse order.
02/2000
4-57
WARNING
Repair-Adjustment
REP 10.5, REP 10.6