RRP 6-7 Horizontal Transport In-Gate Solenoid
Assembly (PL 20.2)
Fig 6-6 In-Gate Solenoid Assembly
Removal
1.
Remove the
Horizontal Transport Rear Cover
2.
Detach the Ground Wire from the Solenoid Cover Assembly.
3.
Unplug the connector (P/J 256M) of the Solenoid Assembly (PL 20.2.14).
4.
Unclamp the harness of the Solenoid Assembly at five places on the Bracket
Assembly (PL 20.2.18).
5.
Pull the Roller (PL 20.2.16) off the shaft of the Bracket Assembly.
6.
Remove two screws that secure the Solenoid Cover Assembly (PL 20.2.20),
and remove the Solenoid Cover Assembly together with the In-Gate Solenoid
Assembly (PL 20.2.99).
Replacement
1.
Secure the Solenoid Cover Assembly to the Horizontal Transport with two
screws.
2.
Attach the Ground Wire, removed in Step 2 above, to the Solenoid Cover
Assembly.
3.
Insert the Roller (PL 20.2.16) onto the shaft of the Bracket Assembly (PL
20.2.18) so that the shoulder faces toward the frame.
4.
Clamp the harness of the Solenoid Assembly at five places on the Bracket
Assembly.
5.
Plug the connector (P/J 256M) of the Solenoid Assembly .
6.
Mount the
Rear Cover
6-720
DocuPrint N4525 Network Laser Printer - Service Guide
.
S4525-427
.