Show Interfaces Transceiver - Dell S4810 Reference Manual

show interfaces transceiver

Display the physical status and operational status of an installed transceiver. The output also displays the
transceiver's serial number.
Syntax
show interfaces [tengigabitethernet slot/port | fortyGigE slot/
port] transceiver
Parameters
tengigabitether
net
fortyGigE
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.5.1.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 6.5.4.0
Usage The following describes the show interfaces transceiver command shown
Information in the following example.
Line
Rx Power
measurement
type
790
For a 10G interface, enter the keyword
tengigabitethernet then the slot/port information.
For a 40G interface, enter the keyword fortyGigE then the
slot/port information.
EXEC
EXEC Privilege
Introduced on theS6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the E-Series ExaScale.
Output augmented with diagnostic data for pluggable media.
Removed three fields in the output: Vendor Name, Vendor
OUI, and Vendor PN.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
Description
Output depends on the vendor, typically either "Average" or
"OMA" (Receiver optical modulation amplitude).
Interfaces