Show Interfaces Transceiver - Dell Force10 S4810P Reference Manual

show interfaces transceiver

installed transceiver. The output also displays the transceiver's serial number.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the transceiver's
serial number.
C-Series, E-Series, S-Series, Z-Series
Syntax show interfaces [gigabitethernet slot/port | tengigabitethernet
slot/port | fortyGigE slot/port] transceiver
Parameters
gigabitethernet
tengigabitetherne
t
fortyGigE
Command Modes
Command History
Version 8.3.11.1
Version 8.5.1.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 6.5.4.0
Usage The following describes the show interfaces transceiver command shown in the
Information Example below.
Line
Rx Power
measurement type
Temp High Alarm
threshold
Voltage High Alarm
threshold
– displays the physical status and operational status of an
For a 10/100/1000 interface, enter the keyword gigabitethernet
followed by the slot/port information.
For a 10G interface, enter the keyword tengigabitethernet
followed by the slot/port information.
For a 40G interface, enter the keyword fortyGigE followed by the
slot/port information.
• EXEC
• EXEC Privilege
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the E-Series ExaScale.
Output augmented with diagnostic data for pluggable media.
Removed three fields in the output: Vendor Name, Vendor OUI, and
Vendor PN.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
Description
Output depends on the vendor, typically either "Average" or "OMA"
(Receiver optical modulation amplitude).
Factory-defined setting, typically in Centigrade. Value differs
between SFPs and SFP+.
Displays the interface index number used by SNMP to identify the
interface.
807