Enable Iproute Sharing - Extreme Networks ExtremeWare XOS Command Reference Manual

IP Unicast Commands

enable iproute sharing

enable iproute sharing
Description
Enables load sharing if multiple routes to the same destination are available. When multiple routes to
the same destination are available, load sharing can be enabled to distribute the traffic to multiple
destination gateways. Only paths with the same lowest cost is will be shared.
Syntax Description
This command has no arguments or variables.
Default
Disabled.
Usage Guidelines
IP route sharing allows multiple equal-cost routes to be used concurrently. IP route sharing can be used
with static routes or with OSPF routes. In OSPF, this capability is referred to as equal cost multipath
(ECMP) routing.
Configure static routes and/or OSPF as you would normally. ExtremeWare XOS supports route sharing
across up to 8 static routes or ECMP routes for OSPF on the BlackDiamond 10K and 4 on the
BlackDiamond 8800 family and Summit X450 switches.
Route sharing is useful only in instances where you are constrained for bandwidth. This is typically not
the case using Extreme switches. Using route sharing makes router troubleshooting more difficult
because of the complexity in predicting the path over which the traffic will travel.
Example
The following command enables load sharing for multiple routes:
enable iproute sharing
History
This command was first available in ExtremeWare XOS 11.1.
Platform Availability
This command is available on all platforms.
1138
ExtremeWare XOS 11.3 Command Reference