Snmp-Server Host; Snmp-Server View - Dell PowerEdge M420 Reference Manual

writeview — A string that is the name of the view that enables the user to
•
enter data and configure the contents of the agent. If unspecified, nothing
is defined for the write view. (Range: 1-30 characters.)
Default Configuration
No group entry exists. There will be some default groups for
Read/Write/Super users. These groups cannot be deleted or modified by the
user. This command is used only to configure the user-defined groups.
Command Mode
Global Configuration Mode
User Guidelines
View-name should be an existing view created using the snmp-server view
command. If there are multiple records with the same view-name, then the
argument specified in this command points to first view-name in the table.
Example
The following example attaches a group called user-group to SNMPv3 and
assigns to the group the privacy security level and read access rights to a view
called user-view.
console(config)# snmp-server group user-group v3 priv
read user-view

snmp-server host

Use the snmp-server host command in Global Configuration mode to specify
the recipient of Simple Network Management Protocol notifications. To
remove the specified host, use the no form of this command. This command
enters the user into SNMP-host configuration mode.
Syntax
snmp-server host
traps version {1 | 2 }]] community-string [udp-port
no snmp-server host
host-addr
[informs [timeout
host-addr
{ traps | informs }
seconds
] [retries
port
] [filter
SNMP Commands
retries
] |
filtername
]
1493