Command Mode
Global Configuration mode.
User Guidelines
An sflow destination entry must have an owner name defined in order for
polling or sampling to be configured. The last set of command parameters are
optional in the no form of the command.
Example
console(config)#sflow 1 destination owner 1 timeout
2000
console(config)#sflow 1 destination maxdatagram 500
console(config)#sflow 1 destination 30.30.30.1 560
sflow polling
Use the sflow polling command to enable a new sflow poller instance for this
data source if rcvr_idx is valid. Use the "no" form of this command to reset
poller parameters to the defaults.
Syntax
rcvr-index
sflow
polling {gigabitethernet | tengigabitethernet}
poll-interval
rcvr-index
no sflow
rcvr-index — The sFlow Receiver associated with the poller (Range: 1–8).
•
interface-list — The list of interfaces to poll in unit/slot/port format.
•
poll-interval — The sFlow instance polling interval. A poll interval of 0
•
disables counter sampling. A value of
sample is generated. (Range: 0–86400).
polling {gigabitethernet | tengigabitethernet}
n means once in n seconds a counter
Sflow Commands
interface-list
interfaces
1463