Snmp-Server V3-Host - Dell PowerEdge M420 Reference Manual

Dell powerconnect m6220/m6348/m8024/m8024-k cli reference guide
Hide thumbs Also See for PowerEdge M420:
Table of Contents

Advertisement

console(config)# snmp-server view user-view
ifEntry.*.1 included
console(config)#snmp-server view "A beautiful view!"
1.1.2.1 included

snmp-server v3-host

Use the snmp-server v3-host command in Global Configuration mode to
specify the recipient of Simple Network Management Protocol Version 3
(SNMPv3) notifications. To remove the specified host, use the no form of
this command.
Syntax
snmp-server v3-host {
[noauth | auth | priv] [timeout
filtername
[filter
no snmp-server v3-host
ip-address — Specifies the IPv4 address of the host (targeted recipient).
hostname — Specifies the name of the host. (Range: 1-158 characters.)
The command allows spaces in the host name when specified in double
quotes. For example, #snmp-server v3-host "host name".
username — Specifies user name used to generate the notification.
(Range: 1-30 characters.)
traps — Indicates that SNMP traps are sent to this host.
informs — Indicates that SNMPv2 informs are sent to this host.
noauth — Specifies sending of a packet without authentication.
auth — Specifies authentication of a packet without encrypting it
priv — Specifies authentication and encryption of a packet.
seconds — Number of seconds to wait for an acknowledgment before
resending informs. This is not allowed for hosts configured to send traps.
The default is 15 seconds. (Range: 1-300 seconds.)
retries — Maximum number of times to resend an inform request. This is
not allowed for hosts configured to send traps. The default is 3 attempts.
(Range: 0-255 retries.)
ip-address
|
seconds
]
ip-address
hostname
username
}
retries
] [retries
{traps | informs}
SNMP Commands
{traps | informs}
port
] [udpport
]
1499

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents