Snmp-Server Location - Dell PowerEdge M420 Reference Manual

User Guidelines
If a DNS host name is entered instead of an IP address, the switch attempts
to resolve the host name immediately using DNS. Use the ip domain-lookup
command on page 466 and the ip name-server command on page 469 to
enable resolution of DNS host names.
Example
The following example enables SNMP traps for host 192.16.12.143.
console(config)# snmp-server host 192.16.12.143
Dell_powerconnect traps v2

snmp-server location

Use the snmp-server location command in Global Configuration mode to set
the system location string. To remove the location string, use the no form of
this command.
Syntax
snmp-server location
no snmp-server location
text — Character string describing the system location. (Range: 1 to 255
•
characters.)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the device location as "New_York".
text
SNMP Commands
1495