Dell PowerEdge M420 Reference Manual page 1597

maxTtl — The largest TTL value that can be used (Range:1–255).
•
maxFail — Terminate the traceroute after failing to receive a response for
•
this number of consecutive probes (Range: 0–255).
interval — The timeout period. If a response is not received within this
•
period of time, then traceroute considers that probe a failure (printing *)
and sends the next probe. If traceroute does receive a response to a probe,
then it sends the next probe immediately. (Range: 1–60 seconds).
count — The number of probes to be sent at each TTL level
•
(Range:1–10).
port — The destination UDP port of the probe. This should be an unused
•
port on the remote destination system (Range: 1–65535).
size — The size, in bytes, of the payload of the Echo Requests sent
•
(Range: 0–65507 bytes).
Default Configuration
The default count is 3 probes.
The default interval is 3 seconds.
The default size is 0 data bytes.
The default port is 33434.
The default initTtl is 1 hop.
The default maxTtl is 30 hops.
The default maxFail is 5 probes.
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Examples
The following example discovers the routes that packets will actually take
when traveling to the destination specified in the command.
console#traceroute 192.168.77.171
System Management Commands
1593