Dell PowerEdge M420 Reference Manual page 1491

Syntax
snmp-server enable traps [acl | all | auto-copy-sw | captive-portal
dot1q | dvrmp | link | maclock | multiple-users | ospf
ospfv3type
|pim |poe | snmp authentication | spanning-tree | stack |vrrp]
no snmp-server enable traps [acl | all| auto-copy-sw | captive-portal
| dot1q | dvrmp | link | maclock| multiple-users | ospf
ospfv3type
| pim | poe | snmp authentication | spanning-tree |stack|vrrp ]
• cp-type - { all, client-auth-failure, client-connect, client-db-full,
client-disconnect }
• ospftype - { all | errors { all | authentication failure | bad packet |
config error | virt authentication failure | virt bad packet | virt config
error } | lsa { all | lsa-maxage | lsa-originate } | overflow { all | lsdb-
overflow | lsdbapproaching- overflow } | retransmit {all | packets |
virt-packets } | state-change { all | if state change | neighbor state
change | virtifstate change | virtneighbor state change }}
• ospfv3type - {all | errors { all | bad packet | config error | virt bad
packet | virt config error } | lsa { all | lsa-maxage | lsa-originate } |
overflow { all | lsdb-overflow | lsdb-approaching-overflow } |
retransmit {all | packets | virt-packets } | state-change { all | if state
change | neighbor state change | virtif state change | virtneighbor
state change }}
Parameter Description
Parameter
acl
all
auto-copy-sw
captive-portal
dot1q
dvmrp
maclock
ospf
ospfv3
Description
Enable traps on ACL match events.
Enable all traps (not recommended).
Enable traps on automatic download of switch software.
Enable captive-portal traps.
Enable traps on VLAN configuration failures.
Enable dvmrp traps.
Enable traps on MAC locking violations.
Enable OSPF event traps.
Enable OSPFv3 event traps.
ospftype
| ospfv3
ospftype
SNMP Commands
cp-type
|
cp-type
| ospfv3
1487