Ip Ospf Priority; Ip Ospf Mtu-Ignore; Ip Ospf Retransmit-Interval - Dell Force10 S2410-01-10GE-24P Command Reference Manual

ip ospf mtu-ignore

Syntax
Default
Mode
Command
History
Related
Commands

ip ospf priority

Syntax
Default
Mode
Command
History
Related
Commands

ip ospf retransmit-interval

| OSPF Commands
436
This command disables OSPF maximum transmission unit (MTU) mismatch detection. OSPF
Database Description packets specify the size of the largest IP packet that can be sent without
fragmentation on the interface. When a router receives a Database Description packet, it examines the
MTU advertised by the neighbor. By default, if the MTU is larger than the router can accept, the
Database Description packet is rejected and the OSPF adjacency is not established.
[no] ip ospf mtu-ignore
The no version of this command enables the OSPF MTU mismatch detection.
Enabled
Interface Config; Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Version 2.3 Added Interface Range and Interface VLAN modes.
interface range Defines an interface range and accesses the Interface Range mode
interface vlan Creates a VLAN or selects an existing one and enters the Interface VLAN mode.
This command sets the OSPF priority for the specified router interface.
ip ospf priority
0-255
The priority of the interface is an integer from 0 to 255. A value of 0 indicates that the router is not
eligible to become the designated router on this network.
The no ip ospf priority command sets the OSPF priority to the default for the specified router
interface.
1 (which is the highest router priority)
Interface Config; Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Version 2.3 Added Interface Range and Interface VLAN modes.
interface range Defines an interface range and accesses the Interface Range mode
interface vlan Creates a VLAN or selects an existing one and enters the Interface VLAN mode.
This command sets the OSPF retransmit interval for the specified interface. The retransmit interval is
specified in seconds.