Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config)#sflow 1 sampling gigabitethernet
1/0/2 1500 50
sflow sampling (Interface Mode)
Use the sflow sampling command in Interface Mode to enable a new sflow
sampler instance for this data source if rcvr_idx is valid. Use the "no" form of
this command to reset sampler parameters to the default.
Syntax
rcvr-index
sflow
rcvr-index
no sflow
rcvr-index — The sFlow Receiver for this sFlow sampler to which flow
•
samples are to be sent. If no receiver is configured, then no packets will be
sampled. Only active receivers can be set. If a receiver expires, then all
samplers associated with the receiver will also expire. (Range: 1 - 8).
sampling-rate — The statistical sampling rate for packet sampling from
•
this source. A sampling rate of 1 counts all packets. A rate of 0 disables
sampling. A value of n means that out of n incoming packets, 1 packet will
be sampled. (Range: 1024 - 65536).
size — The maximum number of bytes that should be copied from the
•
sampler packet (Range: 20 - 256 bytes).
Default Configuration
There are no samplers configured by default.
The default sampling rate is 0.
The default maximum header size is 128.
1466
Sflow Commands
sampling-rate
sampling
sampling
size
[
]