Default Configuration
There are no pollers configured by default.
The default poll interval is 0.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config)#sflow 1 polling gigabitethernet
1/0/1-10 200
sflow polling (Interface Mode)
Use the sflow polling command in Interface Mode to enable a new sflow
poller instance for this data source if rcvr_idx is valid. Use the "no" form of
this command to reset poller parameters to the defaults.
Syntax
rcvr-index
sflow
rcvr-index
no sflow
rcvr-index — The sFlow Receiver associated with the poller (Range: 1 - 8).
•
poll-interval — The sFlow instance polling interval. A poll interval of 0
•
disables counter sampling. A value of n means once in n seconds a counter
sample is generated. (Range: 0 - 86400).
Default Configuration
There are no pollers configured by default.
The default poll interval is 0.
Command Mode
Interface Configuration (Ethernet) mode
1464
Sflow Commands
poll-interval
polling
polling