Reloading management switch 1.
set description
Use the set description command in Stack Global Configuration mode to
associate a text description with a switch in the stack.
Syntax
unit description
set description
unit — The switch identifier. (Range: 1–12)
•
description — The text description. (Range: 1–80 alphanumeric
•
characters)
Default Configuration
This command has no default configuration.
Command Mode
Stack Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays
console(config)#stack
console(config-stack)#set description 1 "unit 1"
slot
NOTE: The slot command is only available to be used on PCM6348 when it is a
master switch in a mixed stack of PCM6348/PC7000 switches to configure the slot on a
slave PC7000 switch.
Use the slot command to configure a slot in the system. The unit/slot is the
slot identifier of the slot located in the specified unit. The
index to the database of the supported card types (see the command show
System Management Commands
cardindex
is the
1551