Default
ip ospf
Syntax
Default
Mode
Command
History
Related
Commands
Command
History
ip ospf areaid
Syntax
Mode
Command
History
Related
Commands
|
OSPF Commands
432
If the value of
is -1, then there is no limit. The range for
limit
-1
Router OSPF Config
This command enables OSPF on a router interface.
[no] ip ospf
The no version of this command disables OSPF on a router interface.
disabled
Interface Config (including Interface Loopback Config mode) or Interface VLAN; Interface Range,
which is indicated by the (conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Version 2.3
interface range
Version 2.5
Modified: Added Interface Loopback Config mode.
Version 2.3
Modified: Added Interface VLAN as a mode.
This command sets the OSPF area to which the specified router interface belongs.
ip ospf areaid areaid
The value for
is an IP address, formatted as a 4-digit dotted-decimal number that
areaid
uniquely identifies the area to which the interface connects. Assigning an area ID that does
not exist on an interface causes the area to be created with default values.
Interface Config or Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Version 2.3
interface range
Defines an interface range and accesses the Interface Range mode
interface vlan
Creates a VLAN or selects an existing one and enters the Interface VLAN mode.
Added Interface Range and Interface VLAN modes.
Defines an interface range and accesses the Interface Range mode
Added Interface Range and Interface VLAN modes.
is -1 to 2147483647.
limit