Isis Tag - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

isis tag

[ no ] isis tag tagValue
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Sets a route tag value for the IP addresses on an IS-IS interface before the route is
Description
propagated to other routers in an IS-IS domain. To use the route tag, you must
reference it in a route map to set values and/or redistribute routes. The no version
removes the route tag from the interface.
Options
Interface Configuration, Subinterface Configuration
Mode
1120
isis tag
tagValue Number in the range 1–4294967295 that identifies the route tag
assigned to the IS-IS interface