Network Area - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

This command is either enabled or disabled. If no OSPF process is identified as the

MIB manager, the first OSPF process is used.

If an OSPF process has been selected, it must be disabled prior to assigning new

process ID the MIB responsibility.

network area

Define which interfaces run OSPF and the OSPF area for those interfaces.

network ip-address mask area area-id

To disable an OSPF area, use the no network ip-address mask area area-

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Open Shortest Path First (OSPFv2 and OSPFv3)

Introduced on the Z9000.

Introduced on the S4810.

Introduced to all platforms.

Specify a primary or secondary address in dotted decimal

format. The primary address is required before adding the

secondary address.

Enter a network mask in /prefix format. (/x)

Enter the OSPF area ID as either a decimal value or in a valid

IP address. Decimal value range is from 0 to 65535. IP

address format is dotted decimal format A.B.C.D.

NOTE: If the area ID is smaller than 65535, it is converted

to a decimal value. For example, if you use an area ID of

0.0.0.1, it is converted to 1.

Introduced on the Z9500.

Introduced on the S4820T.