How To Make Srl Measurements; Setting Sweep Type, Sweep Range, And Number Of Points - Agilent Technologies ENA Series User Manual Supplement

NOTE
Operation
Step 1. Press
NOTE
Step 2. Press
Step 3. Use the following keys to set the sweep range.

How to Make SRL Measurements

A typical SRL measurement consists of the following steps:
1. Setting the sweep type, the sweep range, and the number of points
2. Enabling the SRL function.
3. Setting the average impedance.
4. Calibrate the analyzer.
5. Connect the cable under test
6. Determine the connector model.
7. Perform the SRL Cable Scan
8. Interpret the SRL Measurement
Each step is described on the following pages.

Setting Sweep Type, Sweep Range, and Number of Points

Set the sweep range and the number of points. If you perform the SRL cable scan,
use the VBA utility program to set up the analyzer as described in "SRL Cable Scan
Setup using the VBA Utility Program" on page 70 instead of the following manual
procedures.
The SRL utility program not only sets sweep conditions but also enables the SRL
function and sets the average impedance described in the following sections.
(or
The frequency range and the number of points are common to all the traces in the
channel. If you want to use different settings, make them on another channel.
-
Sweep Type
Chapter 4
Making SRL Measurements
How to Make SRL Measurements
) to activate a channel you want to set.
and select a sweep type with the softkeys.
59