Safety And Regulatory Information; Safety Summary; Equipment Installation - Agilent Technologies N5502A Installation Manual

Phase noise measurement system
Table of Contents

Advertisement

A
Service, Support, and Safety Information

Safety and Regulatory Information

Safety summary

The following general safety precautions must be observed during all
phases of operation of this instrument or system. Failure to comply with
these precautions or with specific warnings elsewhere in this manual
violates safety standards of design, manufacture, and intended use of this
instrument or system. Agilent Technologies, Inc. assumes no liability for
the customer's failure to comply with these requirements.
General
This product has been designed and tested in accordance with the
standards listed on the Manufacturer's Declaration of Conformity, and has
been supplied in a safe condition. The documentation contains information
and warnings that must be followed by the user to ensure safe operation
and to maintain the product in a safe condition.
All light- emitting diodes (LEDs) used in this product are Class 1 LEDs per
IEC 60825- 1.

Equipment Installation

Install the instrument or system so that the detachable power cord is
readily identifiable and is easily reached by the operator. The detachable
power cord is the disconnecting device. It disconnects the mains circuits
from the mains supply before other parts of the instrument or system. The
instrument front panel switch is only a standby switch and is not a LINE
switch. Alternatively, an externally installed switch or circuit breaker
(which is readily identifiable and is easily reached by the operator) may
be used as a disconnecting device.
This is a Safety Class 1 Product (provided with a protective earthing ground
WA R N I N G
incorporated in the power cord). The mains plug shall be inserted only in a socket
outlet provided with a protective earth contact. Any interruption of the protective
conductor inside or outside of the products is likely to make the product
dangerous. Intentional interruption is prohibited (IEC 348 clauses 17.3.3 c and
17.3.4).
This product is designed for use in Installation Category II and Pollution Degree 2.
WA R N I N G
86
E5505A Installation Guide

Advertisement

Table of Contents
loading

Table of Contents