Table of Contents
Advertisement
Safety Summary
The following general safety precautions must be observed during all phases of operation,
service, and repair of this instrument. Failure to comply with these precautions or with speci c
elsewhere in this manual may impair the protection provided by the equipment.
WARNINGS
In addition it violates safety standards of design, manufacture, and intended use of the
instrument.
The Agilent Technologies assumes no liability for the customer's failure to comply with these
requirements.
DO NOT Operate In An Explosive Atmosphere
Do not operate the instrument in the presence of
ammable gasses or fumes. Operation of any
electrical instrument in such an environment constitutes a de nite safety hazard.
Keep Away From Live Circuits
Operating personnel must not remove instrument covers. Component replacement and internal
adjustments must be made by quali ed maintenance personnel. Do not replace components
with the power cable connected. Under certain conditions, dangerous voltages may exist even
with the power cable removed. To avoid injuries, always disconnect power and discharge
circuits before touching them.
DO NOT Service Or Adjust Alone
Do not attempt internal service or adjustment unless another person, capable of rendering rst
aid and resuscitation, is present.
DO NOT Substitute Parts Or Modify Instrument
Because of the danger of introducing additional hazards, do not install substitute parts or
perform unauthorized modi cations to the instrument. Return the instrument to a Agilent
Technologies Sales and Service Oce for service and repair to ensure that safety features are
maintained.
Dangerous Procedure Warnings
, such as the example below, precede potentially dangerous procedures throughout
W arnings
this manual. Instructions contained in the warnings must be followed.
Warning
Dangerous voltages, capable of causing death, are present in this
instrument. Use extreme caution when handling, testing, and adjusting
this instrument.
Safety Symbols
General de nitions of safety symbols used on equipment or in manuals are listed below.
This
condition or the like, which, if not correctly performed or adhered to, could
result in injury or death to personnel.
This
condition or the like, which, if not correctly performed or adhered to, could
result in damage to or destruction of part or all of the product.
Note
practice, condition or the like, which is essential to highlight.
sign denotes a hazard. It calls attention to a procedure, practice,
W arning
sign denotes a hazard. It calls attention to a procedure, practice,
Caution
denotes important information. It calls attention to a procedure,
iii
Advertisement
Table of Contents
