Protocol-Tunnel Rate-Limit - Dell S6100 Configuration Manual

Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.4.1.0
Usage Information Dell Networking OS must have the default CAM profile with the default microcode before you enable L2PT.

protocol-tunnel rate-limit

Enable traffic rate limiting per box.
Syntax protocol-tunnel rate-limit rate
To reset the rate limit to the default, use the no protocol-tunnel rate-limit rate command.
Parameters
rate
Defaults 75 frames per second.
Command Modes CONF-IF-VLAN-STACK
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
Enter the rate in frames per second. The range is from 75 to 3000. The default is 75.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Service Provider Bridging 1479