Rep 8.13 Media Transport Drive Motor And Belt - Xerox 8850 Service Manual

REP 8.13 Media Transport Drive Motor and Belt

Parts List on PL 8.2
Switch off the Main Power Switch. Disconnect the Power Cord.
NOTE: This procedure is primarily concerned with removal of the Media Transport Drive Belt.
Since the Media Transport Drive Motor is also removed in the process, it is also included in the
procedure title.
Removal
1. Remove the Media Transport Module. Perform
2. (Figure 1): Remove the Media Transport Drive Motor and Belt.
4
Remove the Media Transport
Drive Belt
Idler Pulley
1
Disconnect M1P 1 from the Media
Transport Drive Motor
Figure 1 Removing the Media Transport Drive Motor and Belt
Repairs and Adjustments
REP 8.13
WARNING
REP 8.2 Media Transport Module.
3
Remove the Media Transport
Drive Motor
2
Remove the three motor
mount screws
Replacement
NOTE: On reinstallation, ensure that the Media Transport Drive Belt is routed UNDER the Idler
Pulley
1. Reinstallation is the reverse of the Removal procedure.
03/2003
4-44 8850/ 510DP