Rep 10.12 Stack Full Sensor Actuator; Rep 10.13 Stack Full Sensor - Xerox N2125N - DocuPrint B/W Laser Printer Service Manual

REP 10.12 Stack Full Sensor Actuator

Parts List on PL 14.2
Removal
WARNING
Switch off the power and disconnect the Power Cord.
1. Remove the Offset Catch Tray (REP
2. Remove the Exit Tray Extension (REP
3. Remove the Exit Tray (REP 10.3).
4. Turn the Offset Catch Tray upside down.
5. Remove the Lower Cover (REP 10.5).
6. Hold open the Rear Cover.
7. Remove the Inner Exit Chute Assembly
8. Remove the Static Eliminator (REP 10.9).
9. Remove the Stack Full Actuator from the two retaining clips
Figure 1 Stack Full Sensor Actuator
Replacement
1. Reinstall the components in the reverse order.
Initial Issue
DocuPrint N2125
10.1).
10.2).
(REP 10.6).
(Figure 1).

REP 10.13 Stack Full Sensor

Parts List on PL 14.2
Removal
Switch off the power and disconnect the Power Cord.
1. Remove the Offset Catch Tray
2. Remove the Exit Tray Extension
3. Remove the Exit Tray (REP
4. Turn the Offset Catch Tray upside down.
5. Remove the Lower Cover
6. Hold open the Rear Cover.
7. Remove the Inner Exit Chute Assembly
8. Remove the Offset Catch Tray PWB
9. Disconnect P/J225 from the Stack Full Sensor
10. Release the four locking tabs that secure the sensor
Replacement
1. Reinstall the components in the reverse order.
02/2000
4-73
manuals4you.com manuals4you.com
WARNING
(REP 10.1).
(REP 10.2).
10.3).
(REP 10.5).
(REP 10.6).
(REP 10.7).
(Figure 1).
(Figure 1). Remove the sensor.
Figure 1 Stack Full Sensor
REP 10.12, REP 10.13
Repair-Adjustment