Rep 7.2 Tray 1 (Mpt) Feed Roll; Rep 7.3 Tray 2 Feeder - Xerox Phaser 7760 Service Manual

REP 7.2 Tray 1 (MPT) Feed Roll

Parts List on PL 2.13
Removal
1. Open the Left-Hand Door A and locate the Pick Rollers near the Duplex Chute.
2. Rotate the white Retainers to locate the tabs.
3. Lift the Tab and slide the white Retainers away from the Pick Rollers.
4. Slide the Pick Rollers off the Retaining Pins.
5. Lift and remove the Feed Rolls.
Figure 1 Removing Feed Roll
Repairs and Adjustments
REP 7.2, REP 7.3

REP 7.3 Tray 2 Feeder

Parts List on PL 2.3
Removal
1. Remove the Left Lower Cover
2. Pull out Tray 2 halfway.
3. Removing Tray 2 Feeder
a. Disconnect the wiring harness.
b. Remove the 2 screws securing Tray 2 Feeder Assembly.
NOTE: Some manipulation may be required to disengage the gears.
c. Remove Tray 2 Feeder Assembly by sliding out the Feeder Assembly at an angle.
Figure 1 Removing Tray 2 Feeder
January 2010
4-20
(REP 14.12).
(Figure 1).
Phaser 7760 Color Laser Printer
Revised