Be sure to insert the sen-
sor bracket tab into the
slot in the frame
Figure 5 Installing the sensor bracket
Reversion 4.0
WorkCentre 7132
REP 2.3.1 Tray 1 Feed/Nudger/Retard Roll
Parts List on PL 2.3
Removal
NOTE: Only the replacement procedure for the Tray 1 Feed/Nudger/Retard Roll is described
here.
NOTE: When replacing the Tray 1 Feed/Nudger/Retard Roll, enter Diag. mode and clear the
counter for the Tray 1 Feed counter.
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
Check that "Ready to Copy" is displayed on the Control Panel display.
NOTE: The Feed, Nudger and Retard Roll must be replaced at the same time.
1.
Remove Tray 1.
2.
Slide the guide toward the front. (Figure 1)
1.
Slide the guide.
January 2007
4-15
WARNING
CAUTION
Repairs/Adjustments
REP 2.1.1, REP 2.3.1