Configuring A Hybrid-Port-Based Vlan - H3C S7500 Series Operation Manual

Operation Manual – VLAN
H3C S7500 Series Ethernet Switches
Note:
To convert a Trunk port into a Hybrid port (or vice versa), you need to use the
Access port as a medium. For example, the Trunk port has to be configured as an
Access port first and then a Hybrid port.
The default VLAN IDs of the Trunk ports on the local and peer devices must be the
same. Otherwise, packets cannot be transmitted properly.

2.2.3 Configuring a Hybrid-Port-Based VLAN

A Hybrid port may belong to multiple VLANs, and this configuration can only be
performed in Ethernet port view.
Follow these steps to configure the Hybrid-port-based VLAN:
Enter system view
Enter Ethernet port view
Configure the port link
type as Hybrid
Allow the specified VLANs
to pass through the
current Hybrid port
Configure the default
VLAN of the Hybrid port
Note:
To configure a Trunk port into a Hybrid port (or vice versa), you need to use the
Access port as a medium. For example, the Trunk port has to be configured as an
Access port first and then a Hybrid port.
Ensure that the VLANs already exist before configuring them to pass through a
Hybrid port.
The default VLAN IDs of the Hybrid ports on the local and the peer devices must be
the same. Otherwise, packets cannot be transmitted properly.
To do...
system-view
interface interface-type
interface-number
port link-type hybrid
port hybrid vlan
vlan-id-list { tagged |
untagged }
port hybrid pvid vlan
vlan-id
Use the command...
2-5
Chapter 2 VLAN Configuration
Remarks
—
—
Required
Required
By default, all Hybrid ports
only allow packets of
VLAN 1 to pass.
Optional
VLAN 1 is the default by
default