H3C S7500 Series Operation Manual page 896

Operation Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
Figure 1-2 Console port configuration dialog box
Step 5: Click the <Disconnect> button to disconnect the HyperTerminal from the switch
and then click the <Connect> button to reconnect the HyperTerminal to the switch, as
shown in
Figure 1-3 Connect and disconnect buttons
Note:
The new baud rate takes effect only after you disconnect and reconnect the
HyperTerminal program.
Step 6: Press <Enter> to start downloading the program. The system displays the
following information:
Figure 1-3.
Chapter 1 Boot ROM and Host Software
1-6
Loading