Operation Manual – Telnet Protection
H3C S7500 Series Ethernet Switches
1.2 Telnet Protection Configuration
1.2.1 Configuring Telnet Protection
Follow these steps to configure Telnet protection:
To do...
Enter system view
Enable Telnet
protection
Enable global
Telnet protection
or special ARP
Telnet protection
1.2.2 Configuring SNMP Protection
Follow these steps to configure SNMP protection:
To do...
Enter system view
Enable SNMP
protection
Enable global Telnet
protection or special
ARP Telnet
protection
1.2.3 Configuring ICMP Protection
Follow these steps to configure ICMP protection:
Use the command...
system-view
attack-protection telnet
[ ip-address ]
attack-protection
[ ip-address ]
Use the command...
system-view
attack-protection
snmp [ ip-address ]
attack-protection
[ ip-address ]
1-2
Chapter 1 Telnet Protection Configuration
Remarks
—
Required
If you use this command with the
ip-address parameter, you can
protect the packets that match
this source IP address only.
Required
If you use this command with the
ip-address parameter, you can
protect the specified Layer-3
interfaces.
Remarks
—
Required
If you use this command with the
ip-address parameter, you can
protect the packets that match this
source IP address only.
Required
If you use this command with the
ip-address parameter, you can
protect the specified Layer-3
interfaces.