Static Route Configuration Example - H3C S7500 Series Operation Manual

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches

2.4 Static Route Configuration Example

I. Network requirements
It is required that all the hosts/Layer 3 switches in the figure can interconnect with
each other by configuring static routes.
II. Network diagram
1.1.1.1/24
1.1.1 .2/24
Host C
Figure 2-1 Static route configuration
III. Configuration procedure
Note:
Before the following configuration, make sure that the Ethernet link layer works
normally and the IP addresses of the VLAN interfaces have been configured correctly.
# Configure static routes on Switch A.
[SwitchA] ip route-static 1.1.3.0 255.255.255.0 1.1.2.2
[SwitchA] ip route-static 1.1.4.0 255.255.255.0 1.1.2.2
[SwitchA] ip route-static 1.1.5.0 255.255.255.0 1.1.2.2
# Configure static routes on Switch B.
[SwitchB] ip route-static 1.1.2.0 255.255.255.0 1.1.3.1
[SwitchB] ip route-static 1.1.5.0 255.255.255.0 1.1.3.1
[SwitchB] ip route-static 1.1.1.0 255.255.255.0 1.1.3.1
# Configure static routes on Switch C.
[SwitchC] ip route-static 1.1.1.0 255.255.255.0 1.1.2.1
Host A
1.1.5 .2/24
1.1.5.1/24
1 .1.2.2/24 1.1 .3.1/24
Switch C
1 .1.2.1/24 1 .1.3.2/24
Switch A
2-4
Chapter 2 Static Route Configuration
1.1.4.1/24
Switch B
1.1.4.2 /24
Host B