H3C S7500 Series Operation Manual page 317

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches
II. Network diagram
Ethernet
Switch C
Vlan-int 4
Device
Switch A
Switch C
Figure 3-1 RIP configuration
III. Configuration procedure
Note:
Only the configuration related to RIP is listed below. Before the following configuration,
make sure the Ethernet link layer works normally and the IP addresses of VLAN
interfaces are configured correctly.
1) Configure Switch A
# Configure RIP.
<SwitchA>system-view
[SwitchA] rip
[SwitchA-rip] network 110.11.2.0
[SwitchA-rip] network 155.10.1.0
2) Configure Switch B
# Configure RIP.
<SwitchB>system-view
[SwitchB] rip
[SwitchB-rip] network 196.38.165.0
[SwitchB-rip] network 110.11.2.0
3) Configure Switch C
# Configure RIP.
<SwitchC>system-view
Vlan-int 2
Switch A
Vlan-int 1
Interface IP address
Vlan-int1 110.11.2.1/24
Vlan-int2 155.10.1.1/24
Vlan-int1 110.11.2.3/24
Vlan-int4 117.102.0.1/16
3-13
Chapter 3 RIP Configuration
Switch B
Vlan-int 3
Device Interface
Switch B Vlan-int1
Vlan-int3
IP address
110.11.2.2/24
196.38.165.1/24