H3C S7500 Series Operation Manual page 312

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches
Note:
The filter-policy import command filters the RIP routes received from neighbors,
and the routes being filtered out will neither be added to the routing table nor be
advertised to any neighbors.
The filter-policy export command filters all the routes to be advertised, including
the routes imported by using the import-route command as well as RIP routes
learnt from neighbors.
The filter-policy export command without the routing-protocol argument filters all
the routes to be advertised, including the routes imported by the import-route
command.
V. Set RIP preference
Follow these steps to set RIP preference:
To do...
Enter system view
Enter RIP view
Set the RIP
preference
VI. Enable RIP traffic sharing
Follow these steps to enable RIP traffic sharing:
To do...
Enter system view
Enter RIP view
Enable traffic
sharing
VII. Configure RIP route redistribution
Follow these steps to configure RIP route redistribution:
Enter system view
Enter RIP view
Use the command...
system-view
rip
preference value
Use the command...
system-view
rip
traffic-share-across-int
erface
To do...
system-view
rip
—
—
Required
The default RIP preference is 100.
—
—
Required
By default,
traffic-share-across-interface is
disabled
Use the command...
3-8
Chapter 3 RIP Configuration
Remarks
Remarks
Remarks
—
—