H3C S7500 Series Operation Manual page 209

Hide thumbs Also See for S7500 Series:

Table of Contents

Operation Manual – Link Aggregation

H3C S7500 Series Ethernet Switches

# Add Ethernet 2/0/1 through Ethernet 2/0/3 to aggregation group 1.

[H3C] interface ethernet2/0/1

[H3C-Ethernet2/0/1] port link-aggregation group 1

[H3C-Ethernet2/0/1] interface ethernet2/0/2

[H3C-Ethernet2/0/2] port link-aggregation group 1

[H3C-Ethernet2/0/2] interface ethernet2/0/3

[H3C-Ethernet2/0/3] port link-aggregation group 1

Adopt the dynamic LACP aggregation mode

# Enable LACP on Ethernet 2/0/1 through Ethernet 2/0/3.

<H3C> system-view

[H3C] interface Ethernet2/0/1

[H3C-Ethernet2/0/1] lacp enable

[H3C-Ethernet2/0/1] interface Ethernet2/0/2

[H3C-Ethernet2/0/2] lacp enable

[H3C-Ethernet2/0/2] interface Ethernet2/0/3

[H3C-Ethernet2/0/3] lacp enable

Note that the three LACP-enabled ports can be aggregated into a dynamic aggregation

group to implement load sharing only when they have the same basic configuration,

rate and duplex mode.

Chapter 1 Link Aggregation Configuration

Chapters

Table of Contents