Pim-Dm Configuration; Configuring Filtering Policies For Multicast Source/Group; Pim-Sm Configuration - H3C S7500 Series Operation Manual

Operation Manual – Multicast
H3C S7500 Series Ethernet Switches
To do...
Clear PIM neighbors

7.3 PIM-DM Configuration

Perform the following configuration to configure PIM-DM. When the router runs in a
PIM-DM domain, you are recommended to enable PIM-DM on all the interfaces of
non-boarder routers.

7.3.1 Configuring Filtering Policies for Multicast Source/Group

Follow these steps to configure filtering policies for multicast source/group:
Enter system view
Enable the multicast
routing protocol
Enter PIM view
Perform source/group
filter on the received
multicast packets
Caution:
If you configure basic ACLs, the source address match is performed on all the
received multicast packets. The packets failing to match are discarded.
If you configure advanced ACLs, the source address and group address match are
performed on all the received multicast packets. The packets failing to match are
discarded.

7.4 PIM-SM Configuration

Complete the following tasks to configure PIM-SM:
reset pim neighbor { all |
{ neighbor-address | interface
interface-type interface-number } * }
To do... Use the command...
system-view
multicast
routing-enable
pim
source-policy
acl-number
Use the command...
7-13
Chapter 7 PIM Configuration
Remarks
Perform the
configuration in
user view.
Remarks
—
Required
—
Optional
You can configure to filter
the IP addresses of some
multicast groups in an ACL.