Ipx Configuration Example - H3C S7500 Series Operation Manual

Hide thumbs Also See for S7500 Series:

Table of Contents

Operation Manual – IP Address-IP Performance-IPX

H3C S7500 Series Ethernet Switches

3.4 IPX Configuration Example

I. Network requirements

Through an IPX network, Switch A with a node address of 000f-e20f-0000 is connected

to Switch B with a node address of 000f-e20f-0001.

There is a server installed with NetWare 4.1 and assigned a network number of 2. On

the server, the packet encapsulation format is set to Ethernet_II. The client is a PC with

a network number of 3 and a packet encapsulation format of SNAP. The server

provides file service and printing service. The client accesses the file and printing

services provided by the server through the IPX network. The node address of the

server is 0000-0c91-f61f.

II. Network diagram

1000.000f-e20 f-0000

Figure 3-1 IPX network diagram

III. Configuration procedure

Configure Switch A.

# Enable IPX.

<H3C> system-view

[H3C] ipx enable

# Assign the network number 2 to VLAN interface 2 and enable IPX on the VLAN

[H3C] interface Vlan-interface 2

[H3C-Vlan-interface2] ipx network 2

# Set the packet encapsulation format to Ethernet_II on VLAN interface 2.

[H3C-Vlan-interface2] ipx encapsulation ethernet-2

2 .000f-e 20f-0000

1000 .000 f-e 20f-0001

3 .000 f-e 2

Chapter 3 IPX Configuration

Table of Contents