Displaying And Maintaining Ipx Configuration - H3C S7500 Series Operation Manual

Operation Manual – IP Address-IP Performance-IPX
H3C S7500 Series Ethernet Switches
Configure an IPX network
number for the VLAN
interface
Enable triggered update
of IPX
Enable split horizon of IPX
Configure the
encapsulation format of
the IPX frame
Enable the forwarding of
Type 20 broadcast
packets

3.3 Displaying and Maintaining IPX Configuration

View the information of
IPX on the VLAN interface
View the IP packet
statistics
View the IPX service
information table
View the IPX routing
information
Clear the IPX statistics
Clear the IPX routing table
information
To do...
ipx network network
ipx update-change-only
ipx split-horizon
ipx encapsulation [ dot2
| dot3 | ethernet-2 |
snap ]
ipx netbios-propagation
To do...
display ipx interface [ Vlan-interface
vlan-id ]
display ipx statistics
display ipx service-table [ inactive |
name name | network network | order
{ network | type } | type service-type ]
[ verbose ]
display ipx routing-table [ network
[ verbose ] | protocol { default | direct |
rip | static } [ inactive | verbose ] |
statistics | verbose ]
reset ipx statistics
reset ipx routing-table statistics
protocol { all | default | direct | rip |
static }
Use the command...
Use the command...
3-10
Chapter 3 IPX Configuration
Remarks
Required
By default, the system
does not assign network
numbers to VLAN
interface. That is, IPX is
disabled on all the VLAN
interfaces.
Optional
By default, triggered
update of IPX is disabled.
Optional
By default, split-horizon is
enabled.
Optional
By default, the
encapsulation format of
the IPX frame is 802.3
(dot3)
Optional
By default, Type 20
broadcast packets are not
forwarded.
Remarks
Available in
any view
Available in
user view