Clearing Pim Relevant Entries - H3C S7500 Series Operation Manual

Operation Manual – Multicast
H3C S7500 Series Ethernet Switches
Enter VLAN interface view
Enable PIM-DM/PIM-SM
Configure limit on the
number of PIM neighbors
Configure the filtering
policy for PIM neighbors
Caution:
If the number of existing PIM neighbors exceeds the user-defined limit, the existing PIM
neighbors will not be removed.

7.2.4 Clearing PIM Relevant Entries

You can execute the reset command in user view to clear the related statistics about
multicast PIM.
Follow these steps to clear PIM relevant entries:
To do...
Clear the PIM route
entries
To do...
interface Vlan-interface
interface-number
pim dm / pim sm
pim neighbor-limit limit
pim neighbor-policy
acl-number
reset pim routing-table { all |
{ group-address [ mask group-mask |
mask-length group-mask-length ] |
source-address [ mask source-mask |
mask-length source-mask-length ] |
{ incoming-interface { interface-type
interface-number | null } } } * }
Use the command...
Use the command...
7-12
Chapter 7 PIM Configuration
Remarks
—
Required
Configure the
protocol type on
interface.
Optional
By default, the upper limit
on the number of PIM
neighbors on an interface
is 128.
Optional
You can configure to
filter the IP addresses
of some multicast
groups in ACL.
By default, the filtering
policy for neighbors
cannot be enabled on
an interface.
Remarks
Perform the
configuration in
user view.
PIM
the