Configuring Radius Accounting Servers - H3C S7500 Series Operation Manual

Operation Manual – AAA & RADIUS & HWTACACS & EAD
H3C S7500 Series Ethernet Switches

1.4.3 Configuring RADIUS Accounting Servers

Table 1-14 Configure RADIUS accounting server
Enter system view
Create a RADIUS scheme
and enter its view
Set the IP address and
port number of the
primary RADIUS
accounting server
Set the IP address and
port number of the
secondary RADIUS
accounting server
Enable stop-accounting
packet buffering
Set the maximum number
of transmission attempts
of the buffered
stop-accounting packets.
Set the maximum number
of real-time accounting
request attempts
To do...
system-view
radius scheme
radius-scheme-name
primary accounting
ip-address [ port-number ]
secondary accounting
ip-address [ port-number ]
stop-accounting-buffer
enable
retry stop-accounting
retry-times
retry
realtime-accounting
retry-times
Chapter 1 AAA & RADIUS & HWTACACS
Use the command...
1-24
Configuration
Remarks
—
Required
By default, a RADIUS
scheme named system
has already been created
in the system.
Required
By default, the IP address
and UDP port number of
the primary accounting
server are 0.0.0.0 and
1813.
Optional
By default, the IP address
and UDP port number of
the secondary accounting
server are 0.0.0.0 and
1813.
Optional
By default,
stop-accounting packet
buffering is enabled.
Optional
By default, the system
tries at most 500 times to
transmit a buffered
stop-accounting request.
Optional
By default, the maximum
number of real-time
accounting request
attempts is 5. After this
number is reached, the
user connection is cut
down.